Need Advice

[Wayne]

What is the best coolant to use when flushing system on the Vision. How can I identify the relay under tank to install manual on/off switch to fan, and correct way to wire it. Thanks much. Wayne

[Lucky]

use a non silica coolant, any m/c shop will have it.
no need to tap the relay, just splice into the hot wire for the fan, run a wire from the fan to the switch & the switch to ground.

--Lucky

[Wayne]

Thanks-W

[jasonm.]

Lucky, The fan is triggered by a groud to the fan relay. It's much easier to run a ground wire to the relay...if you know where it is. OR find the wires going to the fan switch by the radiator. I put mine in in less than an hour. Using the wires to the switch. Again these are ground(negative) wires.

[Lucky]

my bad, your right, i tapped the ground at the relay...
I forgot.