Custom Vision exhaust

[Brian_Matthewson]

Muffler is titanium from a 2002-3 Yamaha R1, header pipe is a Mac item, modified
with 1 1/2in. mandrel bent 304 stainless steel tubing, rear cylinder ties into muffler inlet tube with some mandrel bent 90 degree tubing, lots of TIG welding, and a couple of stainless steel band clamps.

I still have to make it idle better and the welds on the Mac pipe need more finishing. Performance seems unaffected, weighs about 8-10 lbs less than stock, and it will never rust. Fuel consumption not yet measured.

Pictures....
http://s280.photobucket.com/albums/kk194/brianmatthewson/Custom%20exhaust/
The .mov file is over 7 megs, but if you really want to hear it at idle, take a look.

Brian

[Night Vision]

looks and sounds good Brian, nice job... need another vid with some revs!

[Lucky]

Brian, can you email me a couple of med sized pics since i'm bandwidth challenged?

Thanks!

[Tiger]

 :) Nice one Brian... 8)

                    8).......TIGER....... 8)

[Cdnlouie]

Pretty slick work there Brian  ;).  It looks pretty nice and sounds good too!  Where did you get the stainless pipe and the stainliness clamps?

[Brian_Matthewson]

Stainless pipe from http://www.classictube.com/products_exhaust.asp in Rochester...I was able to buy last year when the Can $ was at par.
Clamps from http://www.clampsinc.com/torca%20series.htm ...the Torctite series.
I also used a 1 1/2 inch clamp from a source that can't recall..