Author Topic: Help with tubes  (Read 233 times)

Tilir

  • ROV Newbie
  • Posts: 3
  • Riders of Vision .net
Help with tubes
« on: July 02, 2018, 11:16:00 PM »
I am having trouble figuring out where a few tubes hook up to. I have a nipple on the front half of my carbs that im confused about and the hose coming out of the top of the airbox. Anyone know where those go?

Rikugun

  • Visionary Grand Master
  • *****
  • Posts: 3210
Re: Help with tubes
« Reply #1 on: July 03, 2018, 08:37:42 AM »
Assuming you are somewhere in North America, it often helps to know if you have an '82 or '83. You might consider adding location and year to your profile.

The airbox hose question was recently covered here: http://ridersofvision.net/rovforum/index.php?topic=15857.0 Hope that helps.

The other might be sending a pulse signal to the fuel pump. It could also go to the petcock or YICS. Maybe someone else can clarify further.
It is far better to grasp the universe as it really is then to persist in delusion, however satisfying or reassuring.  Carl Sagan

Prophet Of Doom

  • Contributing Member
  • Visionary Expert
  • ****
  • Posts: 2581
  • The really perverted one amongst us
Re: Help with tubes
« Reply #2 on: July 04, 2018, 06:00:00 AM »

The carburetor joint for the front cylinder has two vacuum pipes to the petcock and the fuel pump; the joint for the rear cylinder has only one which stays blocked off.
When you are syncing, use the blanked rear port and the petcock front port (smaller hose) for the gauges, and set the petcock to PRI.


The airbox hose (if you have one) goes to the top lip of the front carb
The YICS goes to a port on the intake side of each cylinder just down from the valve cover gasket, if there is any chance the YICS is leaking (do an underwater blow test), you can use blanking covers on these ports also.


By the way, all those cracks in the carburetor are going to do you no good if they are leaking air (and they almost certainly are looking at them).  Good leak free vacuum is critical. 


Tilir

  • ROV Newbie
  • Posts: 3
  • Riders of Vision .net
Re: Help with tubes
« Reply #3 on: July 05, 2018, 03:32:32 PM »
Thank you for the help.