Print Page - Licnese plate frame design............?

Title: Licnese plate frame design............?
Post by: vadasz1 on July 11, 2008, 03:09:00 PM

Is anyone interested in this for their bike or car? I can make either one. Obviously I can customize as I did for the key tag design (which I will have a sample of most likely next week and will have Tiger put his $0.02 in.

Don't mind the green border that's just to indicate where the bleed area is on the template I use.

(http://i281.photobucket.com/albums/kk239/RPendli/VADASZ1--motorcyclelicenseplatefram.jpg)

Title: Re: Licnese plate frame design............?
Post by: vadasz1 on July 11, 2008, 09:41:19 PM

So what yall think boys & girls?

Title: Re: Licnese plate frame design............?
Post by: h2olawyer on July 11, 2008, 10:57:11 PM

With the way Colorado annual registration stickers fit on the plates, most frames are not too workable. I do like the design, though. ;D

H₂O

Title: Re: Licnese plate frame design............?
Post by: Tiger on July 12, 2008, 06:28:44 AM

:) Looks good...but me thinks that you need to make a one-off to see how it fits... :-\ OR pick a cheap one up at Walmart/Canadian Tire for the dimensions ;)

8).......TIGER....... 8)

Title: Re: Licnese plate frame design............?
Post by: YellowJacket! on July 12, 2008, 08:48:49 AM

Doesn't cafepress.com have on for ROV?
EDIT: nope. just checked. T-shirts and mugs and a few other goodies.

David

Title: Re: Licnese plate frame design............?
Post by: vadasz1 on July 12, 2008, 08:52:01 AM

If someone wants a Vision / XZ550 belt buckle that can probably bee done also. I'll talk to my friend and see how much it woud cost to make it from casting.

Just a thought.

Riders Of Vision

General => Board Archives => Topic started by: vadasz1 on July 11, 2008, 03:09:00 PM