Author Topic: What did you do to your vision today?  (Read 58214 times)

Rikugun

  • Visionary Grand Master
  • *****
  • Posts: 3250
Re: What did you do to your vision today?
« Reply #320 on: December 09, 2014, 09:56:55 AM »
Round cross section seals you say - very interesting! Is the fit in the groove loose compared to the square profile seal? No drag when the brake is released and all that good stuff?

I was reading a thread on aussiefrogs.com about Renault R8G's where some calipers came with round seals and some with square. No obvious visual difference to the groove but somewhere a little engraving indicated which seal it came with from the factory. Apparently on later models, regardless of type originally fitted, either seal would work fine.
It is far better to grasp the universe as it really is then to persist in delusion, however satisfying or reassuring.  Carl Sagan

cvincer

  • Contributing Member
  • ROV Full Member
  • ****
  • Posts: 242
Re: What did you do to your vision today?
« Reply #321 on: December 10, 2014, 02:50:15 AM »

They were a good snug fit.  Assume that when the piston went in, the  round  ring compressed into the square section grove even more tightly.

No leaks after 4000kms. No drag noticed whether after braking or just lifting the wheel off the ground & spinning it.

Have also experimented by removing the caliper from the stanchion, inserting an old disc, operating the brake (to hold the disc), & releasing the brake ..... old disc just drops out.

b_racuda

  • ROV Full Member
  • ***
  • Posts: 165
  • Always repairing
Re: What did you do to your vision today?
« Reply #322 on: December 29, 2014, 04:43:01 PM »
Not actually today but yesterday I finally got my garage build to that point that I moved my Vision inside. I think it was time to do that because the temperature was minus 20 degrees of celsius this morning when I woke up. I wasn't worried when the temperature was minus 10 degrees because at the summer I did flush my cooling system and added a bottle of antifreeze in it. Hopefully Vision did survive this and there is nothing but starter issue to be fixed before the summer. When the temperature rises a bit I have to get Vision out because I still have to paint the garage floor with epoxy.

hoverhead47

  • ROV Full Member
  • ***
  • Posts: 46
  • Riders of Vision .net
Re: What did you do to your vision today?
« Reply #323 on: January 04, 2015, 08:50:45 AM »
Not strictly today now but yesterday I went with my local MC Club on a cruise to Apollo Bay via Meredith and Colac and return.  A total of 631 Km.  We avoided freeway and main road running for the most part so we had little to contend with other cars.  Bike did the job but I've gained the Vision hesitation in the two months since I rebuilt the carbs and and possibly a vacuum leak.  Will have to investigate that again.  Was a very long day and I'll probably be suffering tomorrow (today) for it. 

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1025 Views
Last post April 05, 2007, 07:45:05 PM
by jasonm.
4 Replies
1147 Views
Last post June 04, 2007, 10:56:41 AM
by inanecathode
0 Replies
1016 Views
Last post June 11, 2007, 08:54:09 PM
by YellowJacket!
1 Replies
768 Views
Last post September 17, 2007, 02:39:29 PM
by Tiger
12 Replies
3019 Views
Last post October 11, 2012, 11:18:09 PM
by don_vanecek