News:

Main Menu

Rear wheel collar

Started by NAPIER, September 26, 2020, 07:37:30 AM

Previous topic - Next topic

NAPIER

Hi all.
Looking for help with the rear wheel collar, in the Hanes manual page 135 pic 17.6A5 parts list number 90387-172A5.
If anyone has on out ,could please measure it for me as it may have never been in or I lost it.
Thanks
Mark
Yamaha Dt 125
Yamaha Dt 175
Yamaha Dt 250
Yamaha Dt 360
Yamaha Dt400
Yamaha XS 1100
Yamaha Ycs2e
Yamaha Bws
Yamaha RD350 x 3
Yamaha XZ550
Honda CB900F
Nimbus ModelC
Ktm 990

fret not

The part number you supplied shows up as "drive shaft" in the description on the fiche is used on many Yamaha models.  The Haines manual I have does not have part numbers listed, so  you must have gone to a website and looked up the part, and you would also have found it is available for about $10. us. 

A second check calls the part "collar".  At this point you might consider contacting a dealer for clarification as I find it a bit confusing.  Something to consider is that all these parts were designed and manufactured in Japan, and then translated into English. 
Retired, on the downhill slide. . . . . . . . still feels like going uphill!

MikeScoot

Both Luthers had their dreams,
But I've just got one Vision.
Theirs got them into strifes,
Mine just takes me fishin'.

The Prophet of Doom

The part Haynes is pointing at is a lot longer than the parts diagrams would have you believe.  Those diagrams are very confusing at times. 


Here it is:
Length: 70
ID: 17
OD: 24
mm of course.  Looks like it's made of unhardened mild steel. Seamless.

NAPIER

Thank you all for your help, now I can fit the rear wheel.

Regards
Mark
Yamaha Dt 125
Yamaha Dt 175
Yamaha Dt 250
Yamaha Dt 360
Yamaha Dt400
Yamaha XS 1100
Yamaha Ycs2e
Yamaha Bws
Yamaha RD350 x 3
Yamaha XZ550
Honda CB900F
Nimbus ModelC
Ktm 990

NAPIER

Rear wheel on. Thanks.

One stripped carb butterfly screw, so will be looking for left hand drill Monday, busy replacing shaft seals.
Yamaha Dt 125
Yamaha Dt 175
Yamaha Dt 250
Yamaha Dt 360
Yamaha Dt400
Yamaha XS 1100
Yamaha Ycs2e
Yamaha Bws
Yamaha RD350 x 3
Yamaha XZ550
Honda CB900F
Nimbus ModelC
Ktm 990

injuhneer

Quote from: Prophet Of Doom on September 28, 2020, 06:14:07 AM
The part Haynes is pointing at is a lot longer than the parts diagrams would have you believe.  Those diagrams are very confusing at times. 


Here it is:
Length: 70
ID: 17
OD: 24
mm of course.  Looks like it's made of unhardened mild steel. Seamless.

Interesting nomenclature. That looks like a bushing or spacer. I suppose it could be considered a collar for the axle.
- Mike O
1982 Yamaha XZ550RJ