Well back wheel was easier, sort of

Started by MoVision, March 17, 2021, 08:49:28 PM

Previous topic - Next topic

MoVision

It was not at all lol. Had to move the muffler around and I had these plates attached to the rear brake so the rod could come out because the round bearing holding it was of course rusted in. Ended up having to take the entire exhaust system off as that was rusted together and I could not remove just the back half.

But the wheels are off and ready to be done at a shop. Bagged up anything exposed and am cleaning the exhaust system of dirt and what not on the outside. The back half is still being removed as it is fused as one piece, for the time being. Never knew it was a 4-2 system, now I won't feel bad making it 4-6
enjoy the wrenching... This bike was sitting for 24 years in a barn. Took a week to get running until the gas tank started leaking....carbs done, coolant lines redone, brakes, tires, new paint, wiring, coolant reservoir vapor cleaned, front forks repacked, up next rear suspension